Knowledge
How to Polish MIM Stainless Steel Parts?
MIM is the abbreviation of metal injection molding, which is a high-tech technology that combines traditional powder metallurgy technology with plastic injection molding technology. It first mixes the selected powder with the binder, then granulates the mixture and injects it...
MIM (Metal Injection Molding) Mold
MIM molds are different from injection molds in several ways. The thermal conductivity of the feedstock is several times higher than that of plastic, which results in much worse fluidity. The shrinkage rate of MIM molds is usually 15%~22%, which...
MIM Metal Powder Injection Molding: Application in 3c Electronics
MIM process MIM process is a manufacturing technology that combines metal powder injection molding and plastic injection molding. Its basic principle is to mix metal powder and binder to make metal injection molding blanks, then use plastic injection molding machine...
Why is Titanium Alloy a Difficult-to-Process Material?
Titanium alloy refers to a new type of alloy prepared by adding single or multiple other elements based on titanium. Titanium is highly active, and most elements can interact with it to form continuous solid solutions, limited solid solutions, metal...
Four Ways to Strengthen Metal Materials
The strengthening of metal materials is a process of improving the strength and hardness of metals through a series of processes and methods. These strengthening mechanisms are based on the microstructure and properties of metals and are achieved by regulating...
Classification Characteristics and Heat Treatment of Common Stainless Steel Materials
Stainless steel is a type of steel. Steel refers to steel containing less than 2% carbon (C), and more than 2% is iron. During the smelting process, alloy elements such as chromium (Cr), nickel (Ni), manganese (Mn), silicon (Si), titanium...
Introduction to Powder Metals - Titanium
Source of titanium Titanium was first discovered in 1791 by an amateur mineralogist named Gregor in the UK. In 1795, German chemist Klaprous named this unknown metal substance after the Greek god Titans, which is translated into "titanium" in Chinese...
What Are the Advantages of Using a Small Gate for Injection Molding?
The gate is a critical section of the material flow channel in the gating system. Except for the main runner type gate, most gates are the smallest cross-sectional area in the gating system, and their value is generally only 3%...
Six Necessary Conditions for Precision Injection Molding
Precision injection molding refers to an injection molding method in which the size repetition accuracy of the molded product is very high, so that it is difficult to achieve the requirements using a general injection molding machine and conventional injection...